How to Lay a Paver Patio

First, you must choose the area for the patio. Clear the ground of any shrubs or trees to create a flat base. Dig down about 5 inches and spread four inches of gravel. Then, rake and level the ground. Ensure that the bed is even by leveling the pavers and using a two-by-four piece. After this, you can tamp the gravel bed.

Once the area is prepared, the next step is to lay the base. You can use treated lumber or flexible plastic edging to mark out the patio’s perimeter. Make sure that you stake the boards in place to avoid moving them later. After you have bet the lumber, spread coarse sand within the perimeter. Ensure that you have a level, flat surface before laying the patio.

Lay pavers according to the design you want. Make sure to leave a space for sand between each paver. It should be flat, but don’t forget to leave a few inches between each. To get an idea of how many pavers to use, measure the square footage of the entire area. Add 10 percent to account for wastage. After laying out three layers of pavers, you can lay out edging. Make sure to mark the outline at least 8 inches beyond the staked area.

When it comes to installing pavers, the best way to lay them is to start at the corner of the patio or the point at which a triangle is formed. Use a rubber mallet to set the stones in place. Remember that you should never drag the rocks over the sand and avoid stomping them. You can also add sand around the patio’s edge if it isn’t level.

You can fill the gaps between the pavers with polymeric sand. The polymeric sand will help spread the weight evenly on the patio. Moreover, a paver mat is easier to install than gravel. The steps may vary depending on the type of paver mat you choose. In general, however, sand is placed underneath the paver mat. If you’re unsure of the steps to follow, call a landscaping contractor.

Once you have the paver patio, you must prepare the area for the pavers. The best preparation for this is to have a leveled base. The ground may have settled, and the patio may have a hollow section. If the recessed area has an open deck section, you can remove the damaged pavers and fill in the space before laying new pavers.
Before starting the installation, make sure the area is dry and level. You can use polymeric jointing sand to fill the gaps. You can also use a leaf blower to blow off excess sand. Sand should be evenly distributed and swept into the joints. After the pavers have been installed, ensure the area is level and sand the base. If you follow these steps, you can quickly complete similar projects.

Check paver patio Augusta GA for more information